To switch to the map, use the corresponding item in the main menu, or tap the map's icon, which is located in all the available modes to the right of their names. The map shows the units from the work list. By default, the map is centered in such a way that all the units are in sight. Note that geofences created in OnTrak Fleet can be shown on the map of the mobile client (enable the corresponding option in the Settings mode of the OnTrak Fleet mobile client).

Interacting with Map


Zooming
The map is zoomed by special controls located in the bottom right corner of the map. These controls can be enabled/disabled in the Settings mode.

Moreover, map zooming can be made using special gestures:

  • Double tap — zoom in.

  • Single tap with two fingers — zoom out.

  • Pinch with two fingers — zoom in and zoom out, correspondingly.

  • Double tap without releasing on the second tap, then slide the finger down — to zoom in, or up — to zoom out.


Tilt gestures
You can tilt the map by placing two fingers on it and moving them up (increasing tilt angle) or down (decreasing tilt angle).


Map rotation
To rotate the map, place two fingers on it and apply a rotate motion. After the map has been rotated, a compass icon appears in the top right corner. Tap it to return the map to the default position (North in the top of the screen).


Finding Device Location

Finding your own location is an additional feature of the application's map mode (can be used only if the Gurtam Maps cartographic service is selected). Tap the Arrow control in the top right corner if you want your current location to be shown on the map by a marker (the control receives an active state). Upon moving the map and losing the sight of the location marker, the Arrow button changes to the Target one. Tap it to center the map on your location once again.

From the Map mode, you can move to the main menu by tapping the corresponding button in the upper left corner, or to the Track mode (tap the unit icon on the map).


Building a route

To navigate to your destination, tap and hold the required point on the map. In the list that appears, select the application that should be used to build the route (the list is not displayed if there are no appropriate applications). If necessary, the coordinates (address) of the start and finish points can be adjusted in the application used.