After the app is launched, you get to the Units page with the work list. In the work list, you can monitor units' parameters, or you can switch either to the Map or Tracking mode from here.
The work list contains dynamically updated information about units. This information includes current moving state, data actuality, state beginning time, duration, and address. Note that address information can be substituted with the information about unit's presence in geofences. To do so, check the Geofences as addresses box in the Other section of OnTrak Fleet mobile client's settings.
Further, let's explore the possible options for the graphical display of information:
Current state
OnTrak Fleet mobile client uses the GPS speed method to detect movement, regardless of the method selected on the Trip Detection tab. In order to function properly, this method should receive location and speed data. Therefore, to detect movement states, the minimum moving speed value should be higher than 0. Moreover, other settings specified in the Trip detector are used in determining the intervals of movement.
Trip
Stop
Parking
Current state unknown (check trip detection properties)
Last known state is no longer relevant as it was detected more than a week ago
No data from unit
Ignition state
Ignition is on (green circle with a key). Ignition off — the key is not shown
Attention!
The unit's current state, as well as the ignition state, are available only if you have the Query messages or reports access right.
Data actuality
the last message with coordinates was received no more than 5 minutes ago
the last message with coordinates was received no more than an hour ago
the last message with coordinates was received no more than 24 hours ago
the last message with coordinates was received more than a day ago
To go to the unit selection menu, tap the icon 
located next to the search bar.
To add units manually, select the required ones in the list (another tap cancels selection) or use the Select all button, located below the list in Android OS or to the right of the search bar in iOS.
Activate the Units from web monitoring panel option to synchronize the application's work list with the one of the monitoring panel of the OnTrak Fleet web version. If this option is enabled, manual editing of the list is not possible.
When you first log into the app, the work list contains all the units displayed in the work list of the monitoring panel of the OnTrak Fleet web version.
To go back to the work list, you must save or cancel the changes. To do this, use the buttons (
and 
) to the left of the search bar in Android OS or the Save and Cancel buttons at the top of the screen in iOS.